*This SDS for user in JP - Not correspond to the regulation of other countries.
SAFETY DATA SHEET
anac-bio.com
Revision date: July 1, 2024
1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
Product name:
Supplier:
Product name:
Anac001Ex
INOCO LAB JAPAN LTD.
1025, Silk Center Bldg., 1, Yamashita-cho, Naka-ku, Yokohama City, Kanagawa Pref., 231-0023, Japan
Responsible department: Solution Design Department
E-mail: support@anac-bio.com
Fax: +81-(0)45-211-4206
Emergency phone: +81-(0)45-211-4205
2. COMPOSITION / INFORMATION ON INGREDIENTS
CAS#
Unknown
Chemical name
Poly(L-lysine)-g-Dextran
Percent
90-100
EINECS/ELINCS
Unlisted
No ingredients are hazardous according to OSHA criteria.
No components need to be disclosed according to applicable regulations.
3. HAZARD IDENTIFICATION
Classification of the substance or mixture
PHYSICAL HAZARDS: Not classified
HEALTH HAZARDS: Not classified
ENVIRONMENTAL HAZARDS: Not classified
Label elements
Pictograms or hazard symbols: None
Signal word: No signal word
Hazard statements: None
Precautionary statements: None
4. FIRST AID MEASURES
Eyes: In case of eye contact, flush eyes with plenty of water for at least 15 minutes, occasionally lifting the upper and lower eyelids. If irritation develops, seek medical attention.
Skin: In case of skin contact, wash skin with plenty of soap and water. Seek medical attention if irritation develops or persists.
Ingestion: If swallowed, do not induce vomiting unless directed to do so by medical personnel. Never give anything by mouth to an unconscious person. Get medical aid.
Inhalation: If inhalation occurs, remove from exposure and move to fresh air immediately. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Seek medical attention if cough or other symptoms appear.
Notes to physician: Treat symptomatically and supportively.
5. FIRE-FIGHTING MEASURES
General information: As in any fire, wear a self-contained breathing apparatus in pressure-demand, MSHA/NIOSH (approved or equivalent), and full protective gear.
Extinguishing media: In case of fire, use water, dry chemical, chemical foam, or alcohol-resistant foam.
Special hazards: Nature of decomposition not known
Flash point: Not determined
Autoignition temperature: Not available
Explosion limits, lower/upper: Not available
6. ACCIDENTAL RELEASE MEASURES
Personal precautions, protective equipment and emergency procedures: Use personal protective equipment. Keep people away from and upwind of spill/leak. Entry to non-involved personnel should be controlled around the leakage area by roping off, etc.
Environmental precautions: Prevent product from entering drains.
Methods and materials for containment and cleaning up: Sweep dust to collect it into an airtight container, taking care not to disperse it. Adhered or collected material should be promptly disposed of, in accordance with appropriate laws and regulations.
7. HANDLING AND STORAGE
Handling: Provide for appropriate ventilation in places where dust is formed, and wash thoroughly after handling. Avoid contact with eyes, skin, and clothing. Keep product container tightly closed.
Storage: For long-term storage, protect from light, and keep below -20°C.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Components: Contains no substances with occupational exposure limit values
Engineering controls: General industrial hygiene
PERSONAL PROTECTION
Respiratory protection: Dust respirator. Follow local and national regulations.
Skin protection: Handle with gloves that are inspected prior to use. Use proper glove removal techniques to avoid contact with skin. Dispose of gloves in accordance with applicable laws and good laboratory practices.
Eye protection: Use glasses/goggles for eye protection tested and approved under appropriate government standards.
Additional clothing and/or equipment: Safety shower and eye bath
9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance and physical state: White powder
Odor (threshold): Slight
Specific gravity (H2O=1): Not determined
Vapor pressure (mm Hg): Not determined
Vapor density (air=1): Not determined
Percent volatile by volume: Not determined
Evaporation rate (butyl acetate=1): Not determined
Boiling point: Not determined
Freezing point / melting point: Not determined
pH: Not determined
Solubility in water: Not determined
Relative density: Not determined
Partition coefficient (n-octanol/water): Not determined
Auto-ignition temperature: Not determined
Decomposition temperature: Not determined
Viscosity: Not determined
Explosive properties: Not determined
Oxidizing properties: Not determined
10. STABILITY AND REACTIVITY
Reactivity: Not determined
Stability: Stable under recommended storage conditions
Conditions to avoid: Strong oxidizing agents, open flames, high temperature, moisture, and light
Incompatibility: Strong oxidizing agents and strong acids
Hazardous decomposition products: Not determined
Hazardous polymerization: Will not occur
11. TOXICOLOGICAL INFORMATION
Acute Toxicity: No data available
Skin corrosion/irritation: No data available
Serious eye damage/irritation: No data available
Germ cell mutagenicity: No data available
Carcinogenicity:
IARC = No data available
NTP = No data available
Reproductive toxicity: No data available
STOT-single exposure: No data available
STOT-repeated exposure: No data available
Aspiration hazard: No data available
12. ECOLOGICAL INFORMATION
Ecotoxicity:
Fish: No data available
Crustacea: No data available
Algae: No data available
Persistence / degradability: No data available
Bioaccumulative potential(BCF): No data available
Mobility in soil
Log Pow: No data available
Soil adsorption (Koc): No data available
Henry's Law (PaM 3/mol): No data available
Other adverse effects: No data available
13. DISPOSAL CONSIDERATIONS
Waste disposal method: Waste must be disposed of in accordance with federal, state, and local environmental control regulations. Offer surplus and non-recyclable solutions to a licensed disposal company.
14. TRANSPORT INFORMATION
UN-No: Not listed
Hazards Class: Does not correspond to the classification standard of the United Nations
Specific precautionary
Transport measures and conditions:
15. JAPANESE REGULATORY INFORMATION
Not applicable
16. OTHER INFORMATION
The reference company name of written contents.
Company:
Address:
INOCO LAB JAPAN LTD.
1025, Silk Center Bldg., 1, Yamashita-cho, Naka-ku, Yokohama City, Kanagawa Pref., 231-0023, Japan
E-mail: support@anac-bio.com
Phone: +81-(0)45-211-4205
Fax: +81-(0)45-211-4206
Disclaimer: INOCO LAB JAPAN LTD. makes no warranty of any kind regarding the information furnished herein. Users should independently determine the suitability and completeness of information from all sources. While this data is presented in good faith and believed to be accurate, it should be considered only as a supplement to other information gathered by the User. It is the User's responsibility to assure the proper use and disposal of these materials as well as the safety and health of all personnel who may work with or otherwise come in contact with these materials.
NON-HAZARDOUS MATERIAL; APPROVED FOR AIR TRANSPORT
Copyright 2024 INOCO LAB JAPAN LTD.